Customers who have recently upgraded their turn signals to our LED replacements may run into an issue known as hyperflashing. This phenomenon can be observed as the signal indicator light on the dash flashing at a faster pace than usual. If the customer is experiencing this issue, they may need to perform one of the turn signal sync processes outlined below. Completing this sync process will allow your new HOGWORKZ® turn signals to function properly.
2014 and newer models with canbus / BCM electrical systems:
Turn the Ignition on, but do not start the bike
Turn on your 4 way hazards by pressing the hazard button on the controls
Turn the Ignition off letting hazards run. If the bike has security they will flash 5 or 6 times and then pause. This is expected. They will go back to flashing normal hazard mode
Let hazards run 1-2 minutes
Turn the ignition back on
Turn the ignition off and then back on
Check the function of both turn signals
2001-2016 models equipped with a TSSM (Turn Signal Security Module) and are non-canbus / BCM
Turn the ignition on, but do not start the bike.
Turn on the RIGHT side turn signal and let it flash 2 times
Turn on the LEFT side turn signal and let it flash 2 times
Turn on the RIGHT side turn signal again and let flash a minimum of 10 times
Turn on the LEFT side turn signal again and let flash a minimum of 10 times
Turn the ignition key off and then back on.
Check the function of the turn signals
Thanks for riding with HOGWORKZ!